Nora
- 1
- revisión
- 2
- votos útiles
- 3
- calificaciones
-
3D Printing
- De: John M. Jordan
- Narrado por: BJ Harrison
- Duración: 5 h y 3 m
- Versión completa
-
General4 out of 5 stars 9
-
Narración:4 out of 5 stars 8
-
Historia4 out of 5 stars 8
In this volume in the MIT Press Essential Knowledge series, John Jordan offers an accessible introduction to 3-D printing. Jordan outlines the stages of 3-D printing, from idea to software model to a printable file that slices the planned object into printable layers to the finished object itself. He describes additive technologies, consumer 3-D printing in homes and schools, mass customization, and industrial uses.
-
1 out of 5 stars
-
Five hours of naive questions but no answers
- De Nora en 03-19-20
- 3D Printing
- De: John M. Jordan
- Narrado por: BJ Harrison
Five hours of naive questions but no answers
Revisado: 03-19-20
This is not a book that teaches you very much about 3D printing. This is an unorganized book that spends 3 hours trying desperately to convince the reader that 3D will deliver on its previously unfulfilled promises. It then spends 2 hours asking open-ended questions about 3D printing without providing answers to these questions. There is only about 15 minutes of material dedicated to technical aspects of 3D printing. I also found the narrator not very engaging.
Se ha producido un error. Vuelve a intentarlo dentro de unos minutos.
Has calificado esta reseña.
Reportaste esta reseña
esto le resultó útil a 2 personas